Special CNC vacuum cups

Special made CNC vacuum pod with a low profile of only 3 cm. Usually, small CNC Routers have not a wide useful dimension in the Z-axis. This means that in a small router is very hard, if not impossible, to use standard suction cups such as the one 100 mm high because it would reduce too much th...

Mechanical clamp systems are real clamping plates. They are made of anticorrosive aluminum alloy 6082 with plans coated with plastic. The air-fittings are quick-connect fittings nickel-plated. The Group gripper can be equipped with a central bush (which flows around the post) with the function o...

Mechanical clamp for CNC working center. These clamps have a stroke of 40mm and they are made of aluminum and the base can be with "OR rubber" to use the vacuum grip system (such as a standard suction cup) or mechanical. These mechanical clamps are used to increase the stability of a slab on C...

Thanks to the management of compressed air (in-out), this retractable suction cups cup can fall and rise again, keeping the upper position with extreme precision. It is normally used when you want to automatically lower the shelf of the sink after cutting, so as to allow, without stopping the mach...

Pneumatic locating device with a vacuum base. This pin stop locator allows getting an automatic positioning of the workpieces in the CNC table. Body frame in anodized aluminum Rectified Pneumatic Brass cylinder Stainless steel piston Striking pin plastic Viton seals for durabilit...

The manifold suction cup encloses the advantages of a manifold distributor and a suction cup. Made of anodized aluminum, it has only two inputs and 18 outputs. It can be supplied with different heights.

The characteristics of the mushroom clamp are: Anodized aluminum body Stroke 60mm Piston stainless steel Quick couplings for vacuum and air Plans to contact NBR and plastic High clamping force

Rollaway back stop are real automatic centering plates.  They are made of anodized aluminum and stainless steel. These groups allow, thanks to the rotating coil to be used both as reference characters as real side by side. The innovation is in the removal and rotation of the pin so as to exclude ...

If your Breton CNC is equipped with a slatted worktable you cannot use the standard "Manual Pin Stop"  but you have to use this locating device (called also "Flip Stop". Available heights 90 and 150 mm - Breton machines Anodized aluminum body Plans to support plastic Stainless steel...

The manual location devices are used to place the workpieces on the table of your CNC. The pin is retractable and the diameter is 25mm. You drop down the pin after the final positioning of the workpiece and before the start of the production cycle. In this way you can profile around the workpiec...