Engraving CNC Suction Cups – GNC
These are special very low suction cups to use on CNC routers for engravings low relief production work.
If you do not need to work the edge or make through holes, or if you need to work a slab only on the surface then these suction cups are the most convenient and efficient solution to block the slab to be worked.
Available in the Left SX and Right DX versions (see photos) and used in pairs or in groups of 4, one for each corner of the slab to be held.
The size of each suction cup is 150 x 200 mm and the height is 30mm (on request it is possible to make them higher up to 30mm).
The lower surface is made with an O-ring and the quick air couplings can be 6 mm, 8 mm, or 10 mm (write it in the order notes)