Engraving Router bit 90° – 15 mm wide
This is a widia engraving router bit with a tip 90° and wide 15mm. It’s a tool for marble and limestone working and used on cnc machine for engraving, writing and for reliefs’ finishing.
Thank to the 15 mm width of the tip with this tool it’s possible to go deeper in the stone, up to 5/6 mm, if compared to a “standard widia tool with a 90° tip”
Shank diameter of this router bit is 10 mm and it’s available not-holed and holed. The holed type allows inner water flow.
- Spindle speed: 3000/5000 rpm
- Feed rate: 60/80 mm per minute
- Maximum depth per pass: 4/5 mm
- We recommend a ramp input to go inside the material to cut
|Cod: FI15GF||Cod: FI15G|