POLIMIT | Panels for Bridge Saw tables

POLIMIT | Panels for Bridge Saw tables

Polimit Panels for Cutting Tables of Bridge Saws
The material is CFC- and HCFC-free polyurethane based on rigid foam, a high-performance material.
Polimit is an ideal material for use as a table surface for bridge saws when cutting porcelain stoneware and large ceramic slabs.

Table Dimensions:

• Table 180 x 366 cm: 6 panels measuring 90 x 122 x 5 cm
• Table 200 x 366 cm: 6 panels measuring 100 x 122 x 5 cm

Key Features:

• Extremely high-pressure resistance/undeformable
• It does not absorb water
• Resistant to chemicals and extreme temperatures
• Homogeneous material, not laminated
• Easy to apply with screws or adhesive
• Resistant to aging and indestructible

Instructions for Assembling the Polimit Cutting Table:

1. Prepare the surface:
   The surface where the Polimit panels will be placed must be flat and even (a stone surface is ideal) to ensure proper placement without voids.
2. Apply adhesive:
   We suggest the Adhesive sealant Fix All X-treme Power Express – Soudal. Spread the Adhesive evenly and generously across all panels.
3. Create drainage channels:
   Leave a small gap of 2–3 cm between the panels along the length of the table to allow water to drain during operations.
4. Ensure uniform adhesion:
   After gluing the Polimit panels to the existing table, place a heavy weight (such as a slab) on top to ensure even adhesion.
5. Plane the surface:
   Use a wood, marble, or granite milling cutter to lightly plane the surface, ensuring it is perfectly level.
6. Reinforce with screws (if necessary):
   If needed, apply screws at the corners of each panel to enhance the grip further.

Important Note:

If the adhesive is not applied evenly, is used on a wet base or a surface with many voids, or if an unsuitable adhesive is used, partial detachment or swelling of the panel may occur in areas where the adhesive has not adhered properly.