La società MMG SERVICE SRL ha ricevuto nel corso del 2020 e 2021 gli aiuti di stato pubblicati sul RNA sezione Trasparenza.
|AFS91082||Ø23 x 40 / Z5 FB2||1/2 Gas|
|AFS91083||Ø23 x 40 / Z5 FB3||1/2 Gas|
|AFS91084||Ø23 x 50 / Z5 FB2||1/2 Gas|
|AFS91085||Ø23 x 50 / Z5 FB3||1/2 Gas|
|AFS90000||Ø23 L25 LT40||1/2 Gas|
|AFS90065||Ø28 L40 LT95||1/2 Gas|
|AFS90066||Ø28 L40 LT105||1/2 Gas|
|AFS90067||Ø28 L40 LT125||1/2 Gas|
|AFS90080||Ø30 L30 LT40||1/2 Gas|
CNC Finger Bits
Diamond CNC Finger bits for stone fabrication (to work marble, granite, ceramics, and synthetic materials such as Lapitec, Dekton, or Neolith
As with other types of CNC tools, the following general rule applies: use an electroplated finger bit to work materials such as stone and marble; choose a sintered-segment finger bit to work hard stone such as granite, lava stone, basalt, or quartz.
The bonding matrix is a very important factor when choosing the most appropriate sintered-segment finger bit. The bond must be chosen based on the material to cut:
- Use a very soft bond (FB23) when cutting quartz, engineered stone, ceramic, Dekton, Laminam, Lapitec, Neolith…
- Use a soft bond (FB3) when cutting hard quartz
- Use a medium hardness bond (FB2) when cutting medium-hardness materials
- Use a hard bond (FB1) when cutting soft materials
Our vast assortment of Diamond CNC Finger Bits is intended for CNC machines, fabrication centers, and radial-arm machines.
Fingers bits are one of the most common CNC tools used being employed to mill material and cut any type of curve in stone.
We provide different types of finger bits to make fast, accurate, and enduring cuts in any material or job. Specifically, we offer:
- Electroplated finger bits marble
- Sintered hard-bond finger bits for soft stone
- Sintered soft-bond finger bits for hard granite and engineered stone
- Sintered very-soft-bond finger bits designed for the hardest stones like quartzite
Remember, a soft material requires a hard-bond finger bit whereas a hard material requires a soft-bond bit.
1/2” gas is the standard connection, however, we also have interchangeable bit tips with an M10 or M12 thread for the replaceable piece. Cylindrical-shank or flange connections are also available.
The cutting surface of a finger bit is always “on the side”. Never plunge a finger bit into a material in the Z-direction, only use a lateral motion in the X-Y plane. To plunge from top to bottom, use an interchangeable finger bit tip, or the segmented finger bit specifically designed for incremental cuts.
Choosing the right sintered finger bit for a particular job can be confusing due to the vast assortment of bits available. Consult the following chart for assistance:
If you still need information or assistance, please contact us at