Electroplated Engraving Tool 60° for marble
This electroplated engraving router bit has an angle of 60 degrees and it’s used for writing and roughing on marble.
It has a shank of 10mm and it’s holed to allow the flow of the water inside the tool.
When used to make writings and engravings an electroplated tool bit 60° is very fast (feed rate 100/150 mm per minute) but it leaves a rough cut. For example letter grooves on marble made by a widia tool are cleaner than the ones made by an electroplated tool. (Go to: Widia 60° engraving tool)
When making engravings on marble by your CNC machine router it is recommended to proceed as follows:
- 3000/5000 rpm
- Feed rate 100/150 mm per minute.
- Maximum cutting depth per pass: 2/3 mm
- We recommend a ramp input
In this video we show you an electroplated engraving tool with angle 60°:
|Cod: FI60DG||Cod: FI60DGF|